Wall Mount Panel Installation Into Drywall Using Expansion Clips - AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual

Installation
FIG. 6 Plastic pushbutton replacement locations
15. Place the faceplate (A in FIG. 5 on page 9) onto the main AXD unit (B in FIG. 5 on page 9) by
gripping the object at both sides, resting the top rim of the faceplate to the top rim of the
housing, then applying gentle downward force. Make sure to align the Light, IR receiver, and
PIR Motion sensor locations to their respective openings on the front bezel/faceplate. Make
sure the buttons are flush against the faceplate.
16. Reconnect the audio wiring to its respective terminal locations on the selected external audio
equipment for use in conferencing.
17. Reconnect the 4-pin mini-AXlink connector from the panel to the Central Controller and
provide power to the unit.

Wall Mount panel installation into Drywall using Expansion Clips

To install Wall Mount touch panels into plasterboard/drywall:
Expansion clips are mounted through pre-drilled notches located at the sides of the
panel. These clips are one-time use pieces. If and error occurs during the installation
process, a replacement clip must be ordered through your AMX representative.
1. Carefully remove the attached AMX faceplate/bezel (A in FIG. 7 on page 11) from the main
AXD unit (B in FIG. 7 on page 11) by gripping the faceplate from the notches (located along
the underside of the plate) and pulling with gentle force.
2. Cut out the install surface using the dimensions shown in FIG. 8 on page 11. Cut out the two
notches along-side the CP4/A to accommodate the two provided drywall expansion clips.
3. Thread the incoming 4-pin mini-AXlink and 8-pin mini-Audio wiring through the cutout
opening in the wall.
4. Test the wiring by connecting the 4-pin mini-Phoenix connector from the rear AXlink
connector to a PSN6.5 power supply or Central Controller. Verify that the panel is receiving
power and functioning properly to prevent repetition of the installation.
5. Connect both the AXlink and Audio connectors to the rear of the touch panel. Refer to the
Wiring the Touch Panel section on page 21 for more detailed wiring instructions.
10
Menu
Standard pushbutton
Lights
icons (come in 3 colors
Black, Beige, and White)
Audio
Video
Environment
Security
Intercom
Mute
Drapes
Power
Light Sensor
PIR (Passive Infrared)
Sensor
IR Receiver
Microphone
4" Color Touch Panels with Audio