Setting The Level Code; Using The Adjust Sensors Setup Page - AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual

Designing Touch Panel Pages

Setting the level code

Level buttons set the device and number codes for the touch panel.
Joysticks use two level numbers. The first is for the X-axis and the second for the
Y-axis. You only need to specify the first level.
1. Press
2. Enter 1, 2, 3, or 4 in the keypad. The programming software uses device codes
1 - 4 to identify the touch panel.
3. Press
Properties page.
4. Press
5. Enter a number 1 – 8. Each device can have from 1 – 8 levels except joysticks, where the range
is 1 – 7.
6. Press

Using the Adjust Sensors Setup Page

The button illumination, infrared, microphone, speakers, and light sensors on the CP4/A panels
come factory defaulted with values that can be changed by each user to suit their needs. Refer to
the Programming section on page 41 for more detailed information on commands.
This page is used to configure the various features and parameters for the CP4/A panel sensors. To
access the Sensors Setup page:
1. From the Main page press the
2. Press
3. Choose from any of the sensor setup buttons on the Adjust Sensors page (FIG. 30).
FIG. 30 Adjust Sensors page
4. Calibrate the following sensors before the system is used.
34
to open a keypad and set the device number.
DEV
to save the level device number, close the keypad, and return to the Button
ENTER
to open a keypad and set the level number assigned to the device.
NUM
to save, close the keypad, and return to the Button Properties page.
ENTER
SETUP
from the Setup page (FIG. 26 on page 29).
ADJUST SENSORS
adjusts the effective sensitivity (physical detection range) of the Passive
PIR SENSOR
Infrared Sensor. The activation threshold range of the
button.
PIR SENSOR
4" Color Touch Panels with Audio
is 1 - 20. An