Setting The Device Base; Setting The Device Used; Adding A Page - AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Instruction Manual

Designing Touch Panel Pages
FIG. 13 Main page with Edit bar

Setting the Device Base

Press the DEVICE BASE option, in the Protected Setup page (FIG. 12), to assign a base (starting)
device address to the touch panel.
1. Enter the base address for the touch panel. The base address range is from 1 - 255. Standard
device addresses begin at 128.
2. Press Enter to save.

Setting the Device Used

Use the DEVICE USED option in the Protected Setup page (FIG. 12) to assign an initial value for
the device address range used by the touch panel.
1. Press DEVICE USED to open the keypad and enter the panel's device number from 1 - 4. Each
device number supports up to 255 programmable channel codes. The multiple device settings
allow you to create up to four unique touch panel buttons and/or pages. This value is used to
determine the current device being used by the panel.
2. Enter the number of devices being used by the touch panel.
3. Press Enter to save the value.
If DEVICE USED is set to 4 and Base Device Number is 128, the Controller recognizes
bus devices 128 - 131.
The panel will not allow you to enter a device number greater than the DEVICE USED
without first displaying a decision box asking if you accept the new selection or not.

Adding a Page

1. Press PAGE on the Edit bar to open the PAGE menu.
2. Press ADD to open the keyboard and enter a name for the new page. Page names can be up to
20 characters.
3. Press EXIT CHANGE to save, close the keyboard, and go to the new page.
12
Edit bar
AXP-PLV PosiTrack Pilot Video Camera Controller