Configuring A Trunk Group - Cisco SPA2102-AN - Single Port Router Administration Manual

Configuring Voice Services
SIP Trunking and Hunt Groups on the SPA8000
STEP 1
STEP 2
Cisco Small Business ATA Administration Guide

Configuring a Trunk Group

To configure a hunt group, you must first specify the trunk lines by assigning lines
to trunk groups. Then you enter the account information, specify the call capacity,
and configure the Contact List.
Before you begin this procedure, determine which lines you want to associate with
each trunk group that you are configuring. Refer to the following example:
Line
1, 3, 5
4, 6, 8
2
Connect to the administration web server, and choose Admin access with
Advanced settings.
Assign each line to a trunk group, as needed:
a. Click Voice tab > L
b. In the Trunk Group field, near the top of the line configuration page, choose a
trunk number or choose none for a standalone line (the default setting).
c. Repeat this step for each line that you want to add to a trunk group.
Trunk Group
T1
T2
None
n , where n represents the number of the line interface.
Voice > Ln > Trunk Group field
4
82