Vlan Settings Section; Lan Status Page; Networking Service Section - Cisco SPA2102-AN - Single Port Router Administration Manual

ATA Routing Field Reference

LAN Status page

LAN Status page
Cisco Small Business ATA Administration Guide
Maximum Uplink
Speed
Router tab > WAN Setup page >

VLAN Settings section

Enable VLAN
VLAN ID
You can use the LAN Status page to view the LAN settings. This page includes the
following sections:
•
"Networking Service section," on page 111
•
"LAN Networking Settings section," on page 112
•
"Static DHCP Lease Settings section," on page 112
Router tab > LAN Setup page >

Networking Service section

Networking Service
The maximum bandwidth for LAN to WAN throughput.
The default is 128 kbps.
Allows (yes) or prevents (no) VLAN access.
NOTE: Choose yes if your ATA device is connected to
a switch that uses VLAN tagging.
The VLAN tag for the VLAN to which the ATA device is
assigned.
NAT—the unit acts as a router and provides IP
addresses to PCs attached to the LAN port.
Bridge—The unit acts as a switch, a passthrough, and
does not give IP addresses.
A
111