Fxs Port Polarity Configuration Section; Voip-To-Pstn Gateway Setup Section (Spa8800) - Cisco SPA2102-AN - Single Port Router Administration Manual

ATA Voice Field Reference
Line page
Cisco Small Business ATA Administration Guide
Emergency
Number
Voice tab > Line page or Phone page>

FXS Port Polarity Configuration section

On the SPA8800, these settings are configured on the Phone pages only.
Idle Polarity
Caller Conn Polarity Polarity after an outbound call is connected: Forward or
Callee Conn
Polarity
Voice tab > Line page or Phone page>

VoIP-to-PSTN Gateway Setup section (SPA8800)

Line 1 VoIP Caller
DP
Comma separated list of emergency number patterns. If
outbound call matches one of the pattern, SPA will disable
hook flash event handling. The condition is restored to
normal after the phone is on-hook. Blank signifies no
emergency number. Maximum number length is 63
characters.
The default is blank.
Polarity before a call is connected: Forward or Reverse.
The default is Forward.
Reverse.
The default is Forward.
Polarity after an inbound call is connected: Forward or
Reverse.
The default is Forward.
Index of the dial plan in the dial plan pool to be used when
the VoIP Caller is calling from Line 1 of the same SPA8800
unit during normal operation (in other words, not due to
fallback to PSTN service when Line 1 VoIP service is
down). Choose from {none, 1, 2, 3, 4, 5, 6, 7, 8}
Authentication is skipped for Line 1 VoIP caller.
The default is 1.
B
183