Lights/Instruments/Switches - KYMCO AGILITY 125 Service Manual

17

. LIGHTS/INSTRUMENTS/SWITCHES

17
SERVICE INFORMATION ................... 17-0
TROUBLESHOOTING .......................... 17-0
FUEL UNIT .............................................. 17-1
HANDLEBAR SWITCHES.................... 17-2
SERVICE INFORMATION
GENERAL INSTRUCTIONS
An electric tester is needed to measure or test the electric equipment.
Be sure to use fuses and bulbs of the same specifications to avoid damage of electrical
equipment.
After installation of each switch, a continuity check must be performed. A continuity check can
usually be made without removing the part from the motorcycle.
TROUBLESHOOTING
Lights do not come on when ignition
switch is "ON"
Burned bulb
Faulty switch
Broken wire
Fuse burned out
Weak battery
Poorly connected or shorted wire
Faulty winker
Light dims
Faulty ignition coil
Wire or switch resistance too high
Faulty regulator/rectifier
Headlight does not change when dimmer
switch is turn to Hi or Lo
Faulty or burned bulb
Faulty dimmer switch
IGNITION SWITCH ............................ 17-3
STOP SWITCHES/HORN ................... 17-4
INSTRUMENTS.................................... 17-4
HEADLIGHT/LIGHTS........................ 17-5
Fuel gauge pointer does not register
correctly
Disconnected wire or connector
Broken wire
Faulty float
Faulty fuel unit
Faulty instrument
Fuel gauge pointer fluctuates or swings
Loose wire connection
Faulty fuel unit
Faulty instrument
FILLY LX 50
17
17-0