Suppression Of Main Bang - JRC JMA-2343 Instruction Manual

(d) Push the soft key 1 and select
(e) Turn the [GAIN] control to the maximum (turn to maximum clockwise).
(f) Turn the [RAIN] control to the minimum (turn to maximum counterclockwise).
(g) Turn the [SEA] control to the maximum (turn to maximum clockwise).
The strength of the echo on the PPI screen is maximized with sea surface clutter sup-
pression maximized.
(h) Select "STC PRESET" in the menu "INITIAL SETTING 1".
(i) Adjust the level of suppression pushing the "▲ (up)" or "▼ (down)" on the
The PPI screen near the center adjusts to the grade projected slightly.
(j) Push the
ＥＮＴＥＲ ＥＮＴＥＲ ＥＮＴＥＲ ＥＮＴＥＲ
Suppression of sea surface clutter has been set at the maximum level.

9.8.8 Suppression of main bang

This adjustment is undertaken to suppress main bang that is the reflected signal from
three dimensional circuits such as the wave guide that normally appears at the center of
the radar display as a circle.
Optimum adjustment is achieved when the main bang image remains lightly on the
screen.
Attention
This adjustment should not be undertaken without reason. Erroneous adjust-
ment may cause targets that are proximate to be erased from the screen.
(a) Set the range to 0.125NM pushing the "▼ (down)" on the the
(b) Select "OFF" in the line "PROCESS" - the menu "FUNCTION".
(c) Push the soft key
ＥＸＰ ＥＸＰ ＯＦＦ ＥＸＰ ＥＸＰ
key.
.
ＤＩＳＰＬＡＹ ＤＩＳＰＬＡＹ
ＤＩＳＰＬＡＹ ＤＩＳＰＬＡＹ
256
.
ＯＦＦ ＯＦＦ ＯＦＦ
key.
ＲＡＮＧＥ ＲＡＮＧＥ
ＲＡＮＧＥ ＲＡＮＧＥ
key.
ＲＡＮＧＥ ＲＡＮＧＥ
ＲＡＮＧＥ ＲＡＮＧＥ