Connecting An Electromagnetic Compass - JRC JMA-2343 Instruction Manual

Marine radar equipment
Hide thumbs Also See for JMA-2343:
Table of Contents

Advertisement

9.3.6 Connecting an electromagnetic compass

Attention
Ensure that the output of the inboard power supply and rectifier unit and connection to
the power cable is correct.
Erroneous connection or voltage may cause breakdown.
It is possible to input information on bearing to the radar display unit if you use the elec-
tromagnetic compass with a NMEA0183 output terminal.
(It is impossible to connect if you use the electromagnetic compass without a NMEA0183
output terminal.)
(1) Solder the data cable of electromagnetic compass (with NMEA0183 output) to the 8 pin
connector. The polarity is as shown below and care should be taken in making this
connection.
8 pin connector (pin 3)
8 pin connector (pin 4)
Type of LTWD-08BFFA-L180 (JRC code: 5JCDX00015) should be used as the 8 pin
connector.
Unless the connection between the 8 pin connector and data cable is correct,
correct data will not be obtained.
(2) Connect the 8 pin connector to J4 (EXT1) on the rear panel of the display unit.
EXT2
POWER
F1
F2
Radar display unit rear panel
This completes the cabling of the electromagnetic compass.
Electromagnetic compass data (+)
Electromagnetic compass data (-)
GPS
EXT1
SC UNIT
J4
2
8P connector (black)
Electromagnetic compass
1
7
Data -
6
8
3
5
4
Data +
240

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Jma-2344

Table of Contents