Display Of Simulator Image - JRC JMA-2343 Instruction Manual

(d) Push the soft key 1 and select
(e) Push the the soft key
(f) Push the soft key 1 and select
(g) Turn the [GAIN] control to the maximum (turn to maximum clockwise).
(h) Turn the [SEA] control to the mid position.
(i) Turn the [RAIN] control to the minimum (turn to maximum counterclockwise).
(j) Select "MBS LEVEL" in the menu "INITIAL SETTING 1".
(k) Adjust the suppression level pushing the "▲ (up)" or "▼ (down)" on the
(l) Push the
ＥＮＴＥＲ ＥＮＴＥＲ ＥＮＴＥＲ ＥＮＴＥＲ
The suppression level of the main bang has been determined.
(m) Select "MBS RANGE" in the menu "INITIAL SETTING 1".
(n) Adjust the suppression range pushing the "▲ (up)" or "▼ (down)" on the
(o) Push the
ＥＮＴＥＲ ＥＮＴＥＲ
ＥＮＴＥＲ ＥＮＴＥＲ
Adjustment of the suppression range of the main bang has been completed.
9.8.9

Display of simulator image

By activating this function, it is possible to display a demonstration screen on the PPI
screen.
To make the setting of this function effective, the power must be once switched off.
(a) Push the
ＳＴＢＹ／ＯＦＦ ＳＴＢＹ／ＯＦＦ
ＳＴＢＹ／ＯＦＦ ＳＴＢＹ／ＯＦＦ
The display will enter the standby mode.
ＥＸＰ ＥＸＰ ＥＸＰ ＥＸＰ ＯＦＦ ＯＦＦ ＯＦＦ ＯＦＦ
.
ＰＲＯＣＥＳＳ ＰＲＯＣＥＳＳ ＰＲＯＣＥＳＳ ＰＲＯＣＥＳＳ
ＡＵＴＯ ＯＦＦ ＡＵＴＯ
ＡＵＴＯ ＡＵＴＯ
key.
key.
key.
257
.
.
ＯＦＦ
ＯＦＦ ＯＦＦ
key.
ＲＡＮＧＥ ＲＡＮＧＥ ＲＡＮＧＥ ＲＡＮＧＥ
key.
ＲＡＮＧＥ ＲＡＮＧＥ ＲＡＮＧＥ ＲＡＮＧＥ