5. Rotate the foot outward until the foot locks into place.
6. Complete steps 2 on page 12 through 5. for each foot.
Note: When you need to access the inside of the computer to install options, you
Setting the voltage-selection switch
If you have a desktop model, check the position of the voltage-selection switch
located beside the power cord connector. Use a ballpoint pen to slide the switch, if
necessary.
•
•
Connecting computer cables
Use the following steps to set up your computer. Look for the small icons on the
following pages, and on the back of your computer.
Release tab
Feet (unlocked position)
Release tab
might find it easier to lay the computer on its side. If you do so, make sure that
the feet are in the non-stabilizing position. Otherwise, the feet might break off
the computer because of the weight of the computer.
If the voltage supply range in your location is 90-137 V ac, set the switch to 115 V.
If the voltage supply range in your location is 180-265 V ac, set the switch to 230
V.
Feet (locked position)
Voltage switch
115
Chapter 2. Setting up your computer
Guides
Guides
13