IBM INTELLISTATION E PRO 6204 User Manual page 107

Table 11. Diagnostic error messages.
Code Text message
270 Real-time clock error
271 Check date and time
settings
662 Configuration Change
Has Occurred
1762
1780 Hard Disk Error
1781
1782
1783
1800 PCI/PnP Error! No
hardware interrupt
available
1801 PCI/PnP Error! Not
enough space available
to shadow ROM
1802 PCI/PnP Error! Not
enough I/O space
available
1803 PCI/PnP Error! Not
enough memory space
available
1804 PCI/PnP Error! Not
enough real memory
space available.
1805 PCI/PnP Error! Adapter
ROM Checksum Error.
1962 No operating system
found. Press F1 to repeat
boot sequence.
5962 Configuration Change
Has Occurred
Detection
An RTC update cycle
does not occur within the
expected time frame.
RTC time and/or date
values out of range.
A diskette drive has been
added or removed when
in Enhanced POST or
when password is set.
If Enhanced POST,
Enhanced Security, or
any password is set,
when a hard disk has
been added or removed.
A hard disk failed
diagnostics.
Cannot assign interrupt
resource because all are
used.
Cannot initialize option
ROM because address
space is full.
Cannot assign I/O
resource because all are
used.
Cannot assign memory
resource because all
address space is full.
Cannot assign memory
resource because all
address space is full.
PCI option ROM
checksum is invalid.
No device in the boot
sequence has a valid
boot record or boot
vector.
If Enhanced POST,
Enhanced Security, or
any password has been
set, when an ATAPI drive
has been installed or
removed.
Chapter 6. Solving problems
Action
Reset the correct time
and date.
Restore the original
hardware, accept the new
configuration in the IBM
Setup Utility program, or
set the Diskette Drive A:
option correctly.
Accept the new
configuration in the IBM
Setup Utility program or
correct the hardware
problem.
Replace the failing hard
disk drive. If the problem
persists, call for service.
Correct resource
shortage by removing,
disabling, or rearranging
devices.
Remove the device and
correct the checksum.
Press F1 and attempt to
cycle through the startup
sequence. If you do not
press F1, automatically
attempt to cycle through
the startup sequence
every 5 seconds.
Accept the new
configuration in the IBM
Setup Utility program, or
correct the hardware
problem.
91