Notices; Voltage Supply Switch Settings - IBM Aptiva 2156 Hardware Maintenance Service

Notices

References in this publication to IBM products, programs, or services do not
imply that IBM intends to make these available in all countries in which IBM
operates. Any reference to an IBM product, program, or service is not
intended to state or imply that only IBM's product, program, or service may be
used. Any functionally equivalent product, program, or service that does not
infringe any of IBM's intellectual property rights, or other legally protectable
rights, may be used instead of the IBM product, program, or service.
References in this publication to IBM products, programs, or services are
purely hardware-related and do not cover circumstances of software problems.
Evaluation and verification of operation in conjunction with other products,
program, or services, except those expressly designated by IBM are the
user's responsibility.
IBM may have patents or pending patent applications covering subject matter
in this document. The featuring of these patents, pending or otherwise, in this
document does not give you any license to these patents. You can send
license inquires, in writing, to the IBM director of Commercial Relations, IBM
Corporation, Purchase, NY10577.

Voltage Supply Switch Settings

Your IBM Aptiva Personal Computer might have voltage switches, which must
be set correctly for your voltage supply. If your monitor or system unit has a
voltage switch, complete these steps to make sure each switch is set correctly:
1. Determine the correct voltage switch setting for your area:
Voltage Supply Range
100-127 V
200-240 V
2. Locate the voltage switch on the back of your monitor or system unit. If the
setting shown on the switch is:
Correct: start setting up your IBM Aptiva computer.
Incorrect: change the voltage switch setting.
IV
Voltage Switch Setting
110 V
220 V