Setting The Voltage-Selection Switch; Connecting Cables - IBM Aptiva E 2270 User Manual

Setting the voltage-selection switch

Check the position of the voltage-selection switch. Use a ballpoint pen to slide
the switch, if necessary.
• If the voltage supply range is 90–137 V ac, set the switch to 115 V. (This is
the standard setting in North America.)
• If the voltage supply range is 180–265 V ac, set the switch to 230 V.

Connecting cables

The connectors on the rear of the computer have color-coded icons to help you
connect the cables properly. Use the following steps to connect your cables:
1. Connect the keyboard cable to the purple keyboard connector and the mouse
cable to the green mouse connector.
Keyboard
2. Connect the monitor cable to the monitor (if it is not already attached), and
then to the monitor connector; tighten the attachment screws.
3. Connect any additional devices you have.
• Any printer or parallel device.
Voltage Switch
Parallel
Chapter 2. Setting up your computer 7
Mouse