IBM INTELLISTATION E PRO 6204 User Manual page 106

Table 11. Diagnostic error messages.
184
186
190
191
193
195
196
201
210
211
250
90
IBM® IntelliStation® E Pro: User's Guide
Code Text message
Asset Control Antenna
not Detected
Security Hardware
Control Logic Error
System security: Invalid
Remote Change
Requested
System security: IBM
Embedded Security
Hardware Reset.
System security: IBM
Embedded Security
Hardware Removed
System security: Asset
ID Antenna has been
installed
System Tampered
Cleared
Memory Error
Stuck key
Keyboard error
System battery is dead
Replace and run SETUP
Detection
No antenna detected with
AssetCare enabled.
Refer to "Security" on
page 29.
AssetID antenna added.
Refer to "Security" on
page 29.
Failure in Enhanced
POST memory test, or
the SPD indicates an
installed DIMM is not
supported.
When in POST, a stuck
key has been detected.
No keyboard has been
detected.
Bit 7 or RTC Status
Register D is set,
indicating the RTP lost
power.
Action
Auto-configure and
request (accept User
password if no
Administrator password
set).
Refer to "Security" on
page 29.
Refer to AssetID antenna
configuration matrix.
Refer to "Security" on
page 29.
If your computer does not
have the latest level BIOS
code installed, update
the BIOS code to the
latest level.
Ensure that the DIMM is
properly seated.
1. Reseat the failing
DIMM.
2. If the problem
remains, replace the
DIMM.
If the problem persists,
call for service.
Correct the stuck key.
1. Verify that the
keyboard cable is
connected.
2. If the problem
remains, replace the
keyboard cable.
If the problem persists,
call for service.
Replace the battery. See
"Replacing the battery" on
page 110.