Intel Boot Agent Messages - IBM INTELLISTATION E PRO 6204 User Manual

Table 16. NDIS (Windows 2000 or Windows XP) driver teaming messages for the Ethernet controller.
Event ID
33 Warning
34 Warning
35 Warning
36 Error

Intel Boot Agent messages

The Intel Boot Agent might display one or more of the following messages during
initialization:
Table 17. Intel Boot Agent messages.
Type
Explanation: No 802.3ad response from the link partner of any adapters in
the team.
Action:
Explanation: More than one Link Aggegation Group was found. Only one
group will be functional within the team.
Action:
Explanation: Initializing team nn with xx missing adapters.
Action: Check the configuration to verify that all the adapters are present
and functioning.
Explanation: Initializing Team nn failed not all base drivers have the
correct mac address ANS will not load.
Action:
Message
Information messages
This option has been locked
and cannot be changed.
Adapter-related error messages
PXE-04: The LAN adapter
is not functioning correctly
or the wrong Boot Agent is
installed. The Boot Agent
cannot continue.
PXE-05: The LAN
adapter's configuration is
corrupted or has not been
initialized. The Boot Agent
cannot continue.
Description
Description
Explanation: This message appears when you try to
change a configuration setting that has been locked by your
system administrator. This message can appear either from
within the PROSet's Boot Agent tab when operating in
Windows 2000 or Windows XP r from the configuration setup
menu when operating in a stand-alone environment.
Action: If you think you should be able to change the
configuration setting, consult your system administrator.
Explanation: The Boot Agent was unable to read one or
more of the adapter PCI configuration registers. The adapter
might be misconfigured, or the wrong Boot Agent image
might be installed on the adapter. The Boot Agent will return
control to the BIOS and not attempt to remote boot.
Action: Try to update the flash image. If this does not solve
the problem, contact your system administrator or IBM.
Explanation: The Boot Agent determined that the adapter
EEPROM checksum is incorrect. The agent will return
control to the BIOS and not attempt to remote boot.
Action: Try to update the flash image. If this does not solve
the problem, contact your system administrator or IBM.
Chapter 6. Solving problems
105