IBM INTELLISTATION E PRO 6204 User Manual page 87

7. Insert the DIMM into the connector. Firmly press the DIMM straight down into the
connector by applying pressure on both ends of the DIMM simultaneously. The
retaining clips snap into the locked position when the DIMM is firmly seated in the
connector.
8. If a gap exists between the DIMM and the retaining clips, the DIMM has not been
correctly installed. Open the retaining clips, remove the DIMM, then reinsert it.
9. If you have other options to install or remove, do so now.
10. Replace the support bracket.
11. Replace the side cover. See "Replacing the cover" on page 73.
12. Reconnect the external cables and power cords. Turn on the attached devices,
and turn on the computer.
Installing a security U-bolt
To help prevent theft, you can add a security U-bolt and cable to your computer. This
section discusses how to install a security U-bolt.
Do the following to install the U-bolt:
1. Review the safety precautions listed in "Safety information" on page vii.
2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then remove the cover. See "Removing the side cover" on page
58 for details.
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the U-bolt through the rear panel; then attach and tighten the nuts.
DIMM connector 1
DIMM connector 2
DIMM connector 3
Chapter 5. Installing options
71