Poweredge M710Hd Jumper Settings - Dell 8 Owner's Manual

PowerEdge M710HD Jumper Settings

Figure 7-5 shows the location of the configuration jumpers on the blade
system board. Table 7-5 lists the jumper settings.
NOTE:
Figure 7-5 is oriented with the front end of the blade system board facing to
the right.
Table 7-5. PowerEdge M710HD Jumper Settings
PSWD_EN
NVRAM_CLR
(default) The password feature is enabled.
The password feature is disabled.
(default) The configuration settings are retained at
system boot.
The configuration settings are cleared at the
next system boot. (If the configuration settings
become corrupted to the point where the
system does not boot, install the jumper and
boot the system. Remove the jumper before
restoring the configuration information.)
System Board Information
313