Troubleshooting The Blade Board - Dell 8 Owner's Manual

Troubleshooting the Blade Board

1 Remove the blade. See "Removing a Blade" on page 145.
2 Open the blade. See "Opening the Blade" on page 149.
3 Verify that the iDRAC6 Enterprise Card is installed and fully seated on the
system board. See "iDRAC6 Enterprise Card" on page 214.
4 Clear the blade NVRAM.
See "Blade System Board Jumper Settings" on page 309 for the location of
the NVRAM_CLR jumper.
5 If there is a still a problem with the blade, remove and reinstall the blade.
See "Installing a Blade" on page 148.
6 Turn on the blade.
7 Run the system board test in the system diagnostics. See "Running System
Diagnostics" on page 303.
If the tests fail, see "Getting Help" on page 337.
Troubleshooting Your System
301