Dell 8 Owner's Manual page 178

Memory Sparing Support – PowerEdge M710HD
NOTE:
For memory sparing support, your system must be installed with Intel®
Xeon® 5600 series processors.
Memory sparing (spare bank) is supported in systems that have one of the
memory configurations shown in Table 3-8. The memory sparing feature must
also be enabled in the Memory Information screen of the System Setup
program. See "Memory Settings Screen" on page 130. To use memory sparing,
you must disable node interleaving.
Independent Channel Mode (Optimizer Mode) – PowerEdge M710HD
In this mode, all three channels are populated with identical memory
modules. This mode permits a larger total memory capacity, but does not
support the reliability features of the other modes. To enable this mode,
select the Optimizer option on the Memory Settings screen of the System
Setup program. See "Memory Settings Screen" on page 130.
A minimal single-channel configuration of one 1 GB memory module per
processor is also supported in this mode.
Table 3-8. Examples of PowerEdge M710HD Memory Configurations
Total Memory Modules
Physical – Number and
Memory Type
1 GB One 1 GB
UDIMM
2 GB Two 1 GB
UDIMMs
2 GB Two 1 GB
UDIMMs
2 GB Two 1 GB
UDIMMs
4 GB Two 2 GB
UDIMMs
4 GB Two 2 GB
UDIMMs
178
Installing Blade Components
Memory Module Processors Memory
Locations
A1 One
A2, A3 One
A2, A3 One
A1, B1 Two
A2, A3 One
A2, A3 One
Available
Mode Memory
Independent 1 GB
channel
Mirroring 1 GB
Advanced 2 GB
ECC
Independent 2 GB
channel
Mirroring 2 GB
Advanced 4 GB
ECC