Powerconnect M8024 10 Gb Ethernet Switch I/O Module - Dell 8 Owner's Manual

PowerConnect M8024 10 Gb Ethernet Switch I/O Module

The PowerConnect M8024 switch module incorporates two option bays that
support the following modules:
• A 10 Gb Ethernet module with four optical SFP+ connectors
• A 10 Gb Ethernet module with three copper CX4 uplinks
You can initially configure the switch using either of two methods:
• Connect an external management system to the switch using an USB type-
A form factor serial cable, and configure the switch using a terminal
application.
• Use the iKVM CMC console ("17th blade") and the connect switch-n
CMC CLI command. For more information, see the CMC user's guide.
Once an IP address is assigned to the management VLAN or interface and the
switch is connected to a management network, both Telnet and http are
available through the network.
74
About Your System