Figure 3-57. Removing and Installing the Hard-Drive Backplane (Half-Height Blade
Shown)
1
1
hard-drive backplane
3
retention hooks (3)
5
backplane connector
5 To install the hard-drive backplane:
Hold the backplane with the drive connectors facing towards the hard
a
drive bays.
Position the backplane so that the retention hooks on the end of the
b
drive bay are aligned with the corresponding slots in the backplane.
Press the backplane into place until the connector is fully seated and
c
the latches at each end snap over the upper edge of the board.
254
Installing Blade Components
2
5
3
4
2
hard-drive connectors (2)
4
latches (2)