Setting The Auto Surround Mode - Denon AVR-3805 Operating Instructions Manual

4-3 Setting the Auto Surround Mode

The surround mode used at last for the three types of input signals shown below is stored in the memory, and the signal is automatically played
with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
q Analog and PCM 2-channel signals
w 2-channel signals of Dolby Digital, DTS or other multi-channel format
e Multi-channel signals of Dolby Digital, DTS or other multi-channel format
During playback in the PURE DIRECT mode, the surround mode does not change even if the input signal is changed.
1
CH SEL
ENTER
(Remote control unit)
2
CH SEL
ENTER
(Remote control unit)
3
CH SEL
ENTER
(Remote control unit)
4
CH SEL
ENTER
(Remote control unit)
5
Setting the Option Setup
1
CH SEL
ENTER
(Remote control unit)
2
CH SEL
ENTER
(Remote control unit)
44
Select "Auto Surround Mode" at the Advanced
Playback Menu.
CH SEL
ENTER
(Main unit)
Press the ENTER button.
Display the Auto Surround Mode screen.
CH SEL
ENTER
(Main unit)
Select "ON" if you want to use the auto surround
mode, "OFF" if you do not want to use it.
CH SEL
ENTER
(Main unit)
Enter the setting.
The Advanced Playback Menu reappears.
CH SEL
ENTER
(Main unit)
Select "Option Setup" at the System Setup Menu.
CH SEL
ENTER
(Main unit)
Display the Option Setup Menu Screen.
CH SEL
ENTER
(Main unit)