Denon AVR-3805 Operating Instructions Manual page 64

3 Select the play mode.
Example: Stereo
(Remote control unit)
4 Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
5 Adjust the volume.
The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –80 to 0 to 18 dB,
in steps of 0.5 dB. However, when the channel level is set as
described on page 34~36 or pages 72 and 73, if the volume for any
channel is set at +0.5 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is "18 dB — (Maximum value of channel level)".)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS".
64
(Remote control unit) (Main unit)
MASTER VOLUME
(Main unit)
(Remote control unit)
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
• In the EXT.IN mode
Input signal display
• DOLBY DIGITAL
• DTS
Depending on the input signal.
• PCM
• The
DSD
DENON LINK have been connected and
the DSD signals have been inputted.
(See page 14)
Depending on the input signal.
• The
HDCD
signals are being input with a player that
supports HDCD playback.
The DIG. indicator lights when digital signals are being input
DIG.
properly. If the indicator does not light, check whether the
digital input component setup (page 39) and connections are
correct and whether the component's power is turned on.
AL24 processing is activated when PCM signals are played while
the surround mode is set to PURE DIRECT, DIRECT, STEREO,
MULTI CH DIRECT or MULTI CH IN.
NOTE:
• The DIG. indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
Depending on the input signal.
indicator lights when the
indicator lights when digital