Setting The Dolby Digital Downmix Option Setup; Setting The Auto Surround Mode; Setting The Manual Equalizer Setup - Denon AVR-2807 Operating Instructions Manual

Advanced Setup – Part 1
Setting the Dolby Digital Downmix Option
Setup
Turn the audio compression on or off when down-mixing Dolby
Digital signals.
1 D D H H
Press to select "Dolby Digital Setup", then
ENTER
press .
2 F F G G
Press to set.
ON:
The dynamic range is compressed automatically according to
the combination of speakers being used.
Set "Compression" to "ON" if it seems that sound is
distorted because the input level exceeds the allowable input
for the front speakers.
OFF:
The dynamic range is not compressed.
Normally using in this mode.
3
ENTER
Press .
1
2
• When a center speaker or surround speakers are not
connected, the sounds in those channels are directed to the
front speakers.

Setting the Auto Surround Mode

Set whether or not to store the surround mode last played for the
input signal.
The surround mode used at last for the 4 types of input signals
shown below is stored in the memory, and the signal is
automatically played with that surround mode the next time it is
input.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals of Dolby Digital, DTS or other multi-
II
channel format (DOLBY PL x Cinema)
e Multi-channel signals of Dolby Digital, DTS or other multi-
channel format (DOLBY/DTS SURROUND)
r PCM multi-channel signals other than Dolby Digital and
DTS (MULTI CH IN)
Default settings are indicated in ( ).
During playback in the PURE DIRECT mode, the surround
mode does not change even if the input signal is changed.
1 D D H H
Press to select "Auto Surround Mode", then
ENTER
press .
2
F F G G
Press to set.
3
ENTER
Press .
1
2
53
Advanced Setup – Part 1

Setting the Manual Equalizer Setup

Adjust the tone of the various speakers while listening to the
playback signals.
1 D D H H
Press to select "Manual EQ Setup", then
ENTER
press .
2
F F G G ENTER
Press to set, then press
All CH:
All channels can be adjusted simultaneously.
L/R CH:
The left and right channels of the pair of speakers can be
adjusted simultaneously.
Each CH:
The channels can be adjusted separately.
3 F F G G
Press to select the speaker.
The display changes as follows.
q Select "L/R CH"
FL/FR C
SBL/SBR SL/SR
w Select "Each CH"
FL FR C
(2 speakers)
SBR SBL SR
SB
(1 speaker)
e Select "All CH"
In this case, speaker selection is not performed.
4
D D H H
Press to select the frequency, then press
to adjust.
The level of the various frequencies can be adjusted
between –20 dB and +6 dB.
5
ENTER
Press .
.
SL
F F G G