Quick Start - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual

1 Quick Start

This chapter provides a quick overview of the steps required for setting up and
using the HP Server Remote Management Card. If you have experience setting up
computer hardware and software, you can use the following section as a brief
installation guide. Before installing the HP Server Remote Management Card, you
must already have completed initial installation and configuration of your HP
Server. For a brief overview of how the HP Server Remote Management Card
works, see Figure 2-1 before proceeding.
Before you begin, review the "HP Server Remote Management Card System
Requirements" section of Chapter 2.
Figure 1-1. The HP Server Remote Management Card PCI Card Connectors
Install and connect the Remote Management Card (see Chapter 3 for detailed
instructions):
1. Connect one end of the supplied 50-pin ribbon cable to the connector on
the HP Server Remote Management Card.
1