Installing The Diagnostic Panel In The Tc4100 Hp Server; Installing The Diagnostic Panel; Connecting The Cable - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual

Hp server remote management card user guide
Hide thumbs Also See for P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade:
Table of Contents

Advertisement

Appendix I
Installing the Diagnostic Panel in the tc4100 HP
Server

Installing the Diagnostic Panel

1. Power down the HP Server.
2. Disconnect the power cord(s).
WARNING
The power supplies continue to provide standby voltage to the
HP Server until the power cord(s) is/are disconnected.
3. Remove the cover.
4. Snap the Diagnostic Panel into place, as shown in Figure I-3.
NOTE
Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
that the metal of the wrist strap contacts your skin.

Connecting the Cable

The tc4100 HP Server is shipped from the factory with a short cable that is
connected on one end to the front panel. The other end is free, waiting to be
connected to the Visual Diagnostic Panel after it is snapped into place, as shown
in the figure.
110
Installing the Visual Diagnostic Panel

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tc4100Tc3100

Table of Contents