Troubleshooting; When The Server Does Not Start - HP PtoLiant DL140 Setup And Installation Manual

This appendix provides specific troubleshooting information for the HP ProLiant DL140 server.
Use it to diagnose server startup and installation problems.
For information on LEDs, switch settings, and jumpers, refer to Appendix D, "LEDs and
Switch."

When the Server Does Not Start

This section provides step-by-step instructions when encountering the most common problems
during the initial Power-On Self-Test (POST). Every time the server boots, it must complete
POST before it can load the operating system and start running software applications.
If the server completes POST and attempts to load the operating system, go to "Problems After
Initial Startup" in this appendix.
WARNING: There is a risk of personal injury from hazardous energy levels.
The installation of options and the routine maintenance and service of this
product must be performed by individuals who are knowledgeable about the
procedures, precautions, and hazards associated with equipment containing
hazardous energy circuits.
When the server does not start:
1. Be sure that the server and monitor are plugged into a working outlet.
2. Be sure that the power source is working properly:
— Confirm status using the Power On/Off LED.
— Refer to "LEDs and Switches" in Appendix D for the location and status of the
Power On/Off LED.
— Confirm that the Power On/Off button was pressed firmly.
3. Restart the server.
HP ProLiant DL140 Server Setup and Installation Guide
All manuals and user guides at all-guides.com

Troubleshooting

C
45