E Led Codes - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual
Hp server remote management card user guide
Hide thumbs
Also See for P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade:
- Maintenance manual (111 pages) ,
- User manual (48 pages) ,
- Installation manual (38 pages)
Table of Contents
Advertisement
E LED Codes
A failure on the HP Server Remote Management Card is indicated by a flashing
signal pattern displayed by the red diagnostic LED visible below the RS-232 port
(refer to Figure F-1). The other set of LEDs located next to the LAN port indicate
LAN connection activity.
NOTE
Figure F-1. The HP Server Remote Management Card LED
Each failure is stored as a four-digit code. This allows each code up to 10
"sub-codes" that can be interpreted by the diagnostic utility.
In the event that more than one error is affecting card
operation, the HP Server Remote Management Card reports
only the first failure discovered.
89
Advertisement
Table of Contents
