Connecting The 50-Pin Ribbon Cable To The Server - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade User Manual
Hp server remote management card user guide
Hide thumbs
Also See for P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade:
- Maintenance manual (111 pages) ,
- User manual (48 pages) ,
- Installation manual (38 pages)
Table of Contents
Advertisement
Chapter 3
Server is powered down. Serious injury may result if this
warning is not observed.
2. You must plug the Remote Management Card into slot 6.
Connecting the 50-pin Ribbon Cable to the Server
After you have physically installed the HP Server Remote Management Card into
slot 6 of your server, you must cable the card to the server's system board. One
end of the supplied ribbon cable should already be connected to the Remote
Control Card (see previous section). Connect the other end to the system board's
50-pin connector that is immediately adjacent to the inserted card.
NOTE
The ribbon cable is keyed to prevent incorrect cable
connection.
Figure 3-2: Installing the Remote Management Card
Hardware Installation and Configuration
17
Advertisement
Table of Contents
