HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Instructions

Installing the HP Server tc3100

Internal-to-external SCSI Cable Kit

Installing the Optional Internal-to-external SCSI Cable

The HP Server tc3100 can be configured to extend one of its SCSI channels (channel A) to an external SCSI
connector. This allows you to connect additional external mass storage devices to the second channel of the server's
embedded SCSI controller.
1. Remove the IO locking bracket. See Figure 1.
•
Lift the bracket up.
•
Rotate it toward you and slide out.
2. Push the top PCI slot cover from the rear of the chassis to remove it.
3. Connect one end of the cable to the free SCSI connector (Channel A) on the system board. See Figure 2.
4. Route the cable straight back to the open slot and clip it in place at the top.
5. Replace the IO locking bracket and rotate it to close.
HP Part Number 5990-2636, Doc #5990-2636-1
Printed in February 2002
Figure 1. Removing IO Locking Bracket
Figure 2. External SCSI A
*5990-2636*