Connecting the Printer Cables
Connecting to the Ethernet port of the Gigabit Ethernet board
A
Attach two ferrite cores to the Ethernet cable.
Attach the core supplied with the printer to the connector end, making a loop
as shown.
3
B
Connect the Ethernet cable to the Ethernet port that is located on the rear
side of the printer.
C
Connect the other end of the cable to the network, for example using a hub.
Note
❒ For details about attaching the gigabit ethernet board, contact your sales or
service representative.
❒ For details about configuring the network environment, see "Ethernet
Configuration".
Reference
p.39 "Ethernet Configuration"
34
BAL071S
BAL058S