Loading Paper - Ricoh Aficio SP W2470 Hardware Manual

Setting Up

Loading Paper

This section explains what to do when paper runs out and needs reloading.
R CAUTION:
• Be careful when replacing the roll paper or removing misfed paper by follow-
ing the operating instructions properly. Otherwise, an injury may result from
2
the paper cutter inside.
R CAUTION:
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
R CAUTION:
• When replacing or loading the paper roll, do not put the paper roll on the up-
per of the paper roll tray. Otherwise the tray may fall and an injury may re-
sult.
• Hold the paper rolls horizontally with both hands. When you grab the paper
holder and hold the paper roll vertically, the paper roll may fall off and an in-
jury may result.
R CAUTION:
• When replacing or loading the paper, or clearing paper jams, pull out the cut
paper tray slowly with both hands. Do not pull out the cut paper tray with a
single hand. Otherwise the rear of the cut paper tray may fall and an injury
may result.
❖ Default settings
Tray 1 (Paper roll 1): A0 (841 mm)
Tray 2 (Paper roll 2): A2 (420 mm)
Tray 3 (Cut paper): A4K
Bypass tray: A4K
Tray 1 (Paper roll 1): 36 inch
Tray 2 (Paper roll 2): 18 inch
Tray 3 (Cut paper): 12" × 18"K
Bypass tray: 8
20
" × 11"K
1
/
2