Table of Contents
Advertisement
Using DIP Switches to Configure Your I-modem
To do this
Load &FO settings upon reset
Load NVRAM settings upon reset
Ignore AT commands
Enable AT commands
Note: DIP switches 3 and 4 are unused.
Jumpers on the Internal I-modem
Locating Jumpers
Your internal I-modem is set to Plug and Play. You shouldn't have to
change this setting, however, if you have multiple devices connected to
your system, you may need to change the jumper settings to avoid
hardware conflicts.
DIP Switches and Jumpers
Jumpers
Figure 8.8 Jumpers on the Internal Courier
Set DIP
To this setting
Switch
1
OFF
ON(Default)
2
OFF
ON (Default)
12-5
Advertisement
Table of Contents
