Table of Contents
Advertisement
9
Analog Device Channel Terminal Endpoint ID
Typically, ISDN service providers assign TEIs
automatically. If you were given a fixed TEI, type it in
this blank. If not, leave 00.
10
Choose the switch protocol used by your ISDN service
provider.
11
This section is active only if you select AT&T 5ESS
Custom as your switch protocol type. Explained in
Special Considerations for AT&T 5ESS Custom later in
this chapter.
12
This field is active only if you select AT&T 5ESS
Custom as your switch protocol type. Explained in
Special Considerations for AT&T 5ESS Custom later in
this chapter.
13
Controls the volume of the sound from the receiver of a
device that's attached to the Analog Device port. 0 is
quietest and 9 is loudest. 4 is the default and is
recommended.
14
Check all the settings to make sure they're correct, and
then click Save. The following message appears:
15
Select Test to reset the I-modem and begin a 90-second
period of attempts to connect to your central office
switch. Watch the Switch Connectivity Test window.
6-6
Switch Protocol Type
Incoming Modem/Fax Call Routing
Bus Configuration
Audio Port Volume
Save Button
Test Button
Courier I-modem Getting Started Guide
Advertisement
Table of Contents
