Table of Contents
Advertisement
2
Set the appropriate bus configuration.
To set
Point to point
Multipoint
3
Set up the ANALOG DEVICE B-channel.
a
b
c
7-4
Set the Service Profile Identifier (SPID).
The command is AT*S1=n
Example: AT*S1=84755511110111 <Enter>
Set the Directory Number (DN).
The command is AT*P1=n
Example: AT*P1=5551111
Set the Terminal Endpoint Identifier (TEI), if you were
assigned one. If not, continue with step d.
The default setting is 0, or dynamic TEI assignment. The
TEI permanently identifies your link with the central office
switch.
The command is AT*T1=n
If your TEI
Is dynamic
Is fixed
Use this command
AT*M=0
AT*M=1
Use this command
AT*T1=00
AT*T1=n, where n is a number from 1 to 63.
Courier I-modem Getting Started Guide
Advertisement
Table of Contents
