Table of Contents
Advertisement
11
To use
Analog
Device Port
Data Port
12
If You Have One SPID and One DN
2
3
7
8
10
11
To use
To Analog
Device Port
To Data Port
12
6-10
Incoming Modem/Fax Call Routing
Select one of the following:
The I-modem routes incoming analog calls
To the Analog Device port (handled by the device
attached to the Analog Device port).
To the Data Port (handled by the I-modem).
Bus Configuration
Select Point-to-Point.
Make these modifications when entering your line
configuration.
Data Channel Service Profile ID
Enter your SPID (up to 20 digits).
Data Channel Directory Number
Enter your DN. Do not include your area code.
Analog Device Channel Service Profile ID
Enter your SPID (up to 20 digits).
This field should be blank if you have only on SPID.
Analog Device Channel Directory Number
Enter your DN. Do not include your area code.
Switch Protocol Type
Select AT&T 5ESS Custom.
Incoming Modem/Fax Call Routing
Select one of the following:
The I-modem routes incoming calls
To the Analog Device port (handled by the
device attached to the Analog Device port).
To the Data Port (handled by the I-modem).
Bus Configuration
Select Multipoint.
Courier I-modem Getting Started Guide
Advertisement
Table of Contents
