Table of Contents
Advertisement
d
You are done configuring your I-modem.
Step Two: Checking the Configuration
Send ATI12 <Enter>, and check that the settings you made are
correct.
Step Three: Saving the Configuration
Reset the I-modem by sending ATZ! <Enter> or power off the
modem and power it on again.
Sending ATZ is not sufficient! Send ATZ! <Enter> Your settings
will not take effect until the I-modem undergoes this type of reset.
Note: If your phone company requires compliance with Bellcore
Special Report NWT 1953, which introduces a random delay of 45 to
65 seconds when bringing up your line, you can set the I-modem to
comply by sending ATS67.4=1 <Enter>. To disable compliance, send
ATS67.4=0 <Enter>.
7-6
Set the Call Type.
Note: The call type you choose will apply to both
incoming and outgoing calls.
The command is AT*V2=n
To set this call rype
Automatic service choice
(Universal Connect)
V.120 rate adaption calls only
V.110 rate adaption calls only
Modem or fax emulation only
Clear-channel synchronous calls
only
Internet access mode (default)
Use this command
AT*V2=0
AT*V2=1
AT*V2=2
AT*V2=3
AT*V2=4
AT*V2=5
Courier I-modem Getting Started Guide
Advertisement
Table of Contents
