Table of Contents
Advertisement
This LED
Status
MR
On
Flashing
Off
RTS
On
Off
CTS
On
Off
SYN
On
Blinking
Off
ARQ/FAX
On
Flashing
Blinking
Off
Configuring the Courier 56K Corporate Modem with DIP
Switches
Locating DIP Switches
On the Courier 56K Corporate Modem, the DIP switches are on the bottom of the
unit. The default setting is DIP switches 3, 5, and 8 are ON (in the down position).
Means your Courier 56K Corporate Modem
Is powered on
Is retraining with a remote device or is in Test mode
Is powered off
Has detected the Ready to Send (RTS) signal from your
computer
Has not detected the RTS signal from your computer
Is sending your computer the Clear to Send (CTS) signal
Is not sending your computer the CTS signal
Is in synchronous mode
Has activated Dial Security
Is not in synchronous mode/Dial Security not active
Is using V.42 bis error correction
Is retransmitting data to the remote modem
Is in fax mode
Is not using error control, not retransmitting data, and not
faxing
DIP Switches
11
Advertisement
Table of Contents
