Table of Contents
Advertisement
If You Are Using MS-DOS
Because there is no communications software built in to MS-DOS, you
must install and run a third-party communications software package to
operate your I-modem.
RapidComm, which is included on the Connections CD-ROM, contains
MS-DOS and Windows 3.1 versions of RapidComm.
You must choose the COM port to which your I-modem is attached in
whatever communications software package you are using.
For instructions about how to set up your MS-DOS communications
software package, see the software documentation or visit the U.S.
Robotics Totalservice web site at http:/ / totalservice.usr.com.
For Internal Couriers Only
You must choose the COM port, IRQ, and the I/O address within the
communications software that you use. These are the standard I/O
address and IRQ settings for each COM port:
COM Port
COM1
COM2
COM3
COM4
Other Operating Systems
I/O Address
03F8
02F8
03E8
02E8
IRQ
IRQ4
IRQ3
IRQ4
IRQ3
10-3
Advertisement
Table of Contents
