Using Dip Switches To Configure Your Courier - US Robotics Courier V.Everything Getting Started Manual

Using DIP Switches to Configure Your Courier

To do this
Set DTR to Normal
Ignore DTR
Set verbal result code display
Set numeric result code display
Disable result codes
Enable result codes
Enable the echo in offline commands
Disable the echo in offline commands
Enable auto answer
Disable auto answer
Enable normal Carrier Detect
Disable normal Carrier Detect
Display result codes In ALL modes
Display result codes in orginate mode only
Disable AT commands
Enable AT commands
Disconnect on escape (+++)
Don't disconnect on escape (+++)
Load the configuration that is stored in non-
volatile memory (NVRAM)
Load the &F0 configuration from read-only
memory (ROM)
DIP Switches and Jumpers
Set DIP To this setting
Switch
1 OFF (Default)
ON
2 OFF (Default)
ON
3 OFF
ON (Default)
4 OFF (Default)
ON
5 OFF
ON (Default)
6 OFF (Default)
ON
7 OFF (Default)
ON
8 OFF
ON (Default)
9 OFF (Default)
ON
10 OFF (Default)
ON
7-3