Table of Contents
Advertisement
d
4
Set up the DATA B-channel.
a
b
c
Configuring with AT commands
Set the Call Type.
Note: The call type that you choose will apply to outgoing
calls only.
The command is AT*V1=n
To set this call type
3.1 kHz audio (for modem,
fax, or voice calls)
Speech only
Set the Service Profile Identifier (SPID).
The command is AT*S2=n
Example: AT*S2=84755511120111
Set the Directory Number (DN).
The command is AT*P2=n
Example: AT*P2=5551112
Set the Terminal Endpoint Identifier (TEI), if you were
assigned one. If not, continue with step d.
The default setting is 0, or dynamic TEI assignment.
The command is AT*T2=n
If your TEI
Is dynamic
Is fixed
Use this command
AT*V1=0
AT*V1=1
Use this command
AT*T2=00
AT*T2=n, where n is a number from 1
to 63.
7-5
Advertisement
Table of Contents
