Lexmark Dot Matrix User Manual page 12

Learning about the printer
2
Plug the printer power cord to a properly grounded electrical outlet.
Note: The Power light comes on and turns solid green, the Paper Out light is blinking, and the current default
font light is solid green. For more information on the control panel lights, see "Understanding the control panel
lights" on page 18
3
Open the manual feeder, and then move the paper select lever to the
4
Move the left paper guide to the right until it stops.
5
Insert a single sheet of paper into the front of the printer.
6
Adjust the right paper guide to fit the paper width.
7
Continue pushing the paper into the printer until the Paper Out light stops blinking.
•
If Auto Cut Sheet Load is set to On, then the paper feeds automatically to the Top‑Of‑Form.
•
If Auto Cut Sheet Load is set to Off, then press FormFeed.
8
Press and hold Start/Stop for five seconds.
9
Press Font and Start/Stop.
Note: Hold down the Font button until all the control panel lights blink.
10
Release the Font button.
Note: The Power and Ready lights stay on, and the demonstration page prints.
position.
12