Automapping; Automapping With User-Specified Key And Certificate; Automapping With Multiple Port Combinations; Deleting Automapping Entries - HP P4518A - Traffic Management Server Sa7150 User Manual

C H A P T E R 3
NOTE: Remember to
save the configuration
(with the config save
command) after making
mapping changes.
SSL Processing

Automapping

Automapped entries are identified by a server IP address of zero
(0.0.0.0). When a server IP address of zero is specified, the SA7150
intercepts packets to any server IP address with the matching network
ports. As with any mapping entry, the combination of server IP
address and network port must be unique.
The initial configuration for the SA7150 provides an automapping
entry for network port 443 and server port 80. This is associated with
the internally generated default keypair and certificate with the keyID
of "default." Under this initial configuration, automapping occurs on
any server with this network port (443) when traffic is routed through
the SA7150.
Automapping with user-specified key and
certificate
When a user-specified key and certificate are to be automapped, the
user can replace the initial automapping entry with the create map
command. By specifying the same unique identifier (server IP of
0.0.0.0, and network port of 443 with a user-generated keyID), the
user can overwrite the initial automapping entry. (The key and
certificate may be obtained through any of the methods described
previously in this chapter.)

Automapping with multiple port combinations

The user can specify multiple automapping entries when the network
port is unique. For example, a user might specify, in addition to the
initial network (443) and server (80) port combination, a combination
of network (8010) and server (80) port.

Deleting automapping entries

Any automapping entry can be deleted, but if the initial automapping
is deleted and no other mapping entry is specified, the SA7150
automatically recreates the initial automapping entry. Either replace
the initial automapping entry or create another mapping/automapping
entry and then delete the initial automapping entry using the delete
map command.
47