Remote Ssh Sessions; Local Serial Console - HP P4518A - Traffic Management Server Sa7150 User Manual

C H A P T E R 6

Remote SSH Sessions

NOTE: The default user
name and password for
SSH sessions are admin.
Local Serial
Console
Remote SSH Sessions
This section contains procedures for accessing the SA7150's CLI via
remote Secure Shell (SSH) session. The table below illustrates
ciphers supported by the domestically available SA7150 under SSH1
and SSH2. The export version of the product supports only the SSH2
cipher DES.
SSH1
Cipher 3DES, DES, Blowfish
MAC
Assign an IP address to the SA7150's network interface using the
following procedure:
HP SA7150> set ip
Enter IP Address ('none' to delete)
[10.1.2.65]: 10.1.1.1
Enter Netmask ('none' to delete)
[255.255.255.0]: 255.255.255.0
Verify the IP and netmask (optional):
HP SA7150> show ip
System IP Address: 10.1.1.1
System Netmask: 255.255.255.0
Enable remote SSH sessions:
HP SA7150> set ssh enable
Configure the network route:
HP SA7150> set route
Enter Default Route ('none' to delete)
[10.1.1.1] :
Verify the route configuration (optional):
HP SA7150> show route
Default Route : 10.1.1.1
SSH2
3DES, Twofish, RC4,
"None"
MD5, "None"
Supported Ciphers
119