Disabling Remote Boot; Recovering Data - Intel SS4000-E - Entry Storage System NAS Server User Manual

Protecting Local Disks
6. When a message displays, advising you that drivers will install, click OK.
7. When the drivers are installed, one or more messages might display, advising you that
these drivers are not signed. This has no adverse effect on your system. Click
Continue Anyway or Yes on each message to proceed with the installation.
In addition, the Found New Hardware Wizard starts. Select No, Not this Time on the
initial screen and complete the rest of the wizard, accepting all the default values.
If remote boot was successfully enabled as indicated in the Details area, a new backup
is created.
Note: If remote boot was successfully enabled but for some reason the new backup
8. Click Close. If no problems were encountered, you can now remotely boot from the
storage system as described in
on page
If any problems were encountered, take corrective action. For example, if you did not
previously protect a system disk or partition, do so now as described in
Your Disks" on page
of the process complete successfully.

Disabling Remote Boot

Disabling remote boot restarts your computer automatically. It is recommended that you
save and close any open files on your system before you do this.
To disable remote boot:
1. From the Action menu, click Disable Remote Boot. A progress bar displays the
progress of the process.
2. When the confirmation message displays, click OK. Your computer restarts.

Recovering Data

With Intel
backups. The best method depends on your goals and the capabilities of your computer:
•
Recover selected folders, files, or sections of files—If you accidentally permanently
deleted a file or folder that you want to recover, or if you just want to retrieve some
information from a file that you changed, you can access the backup that contains the
desired data and copy it to your local disk.
You can use this procedure to try out different "what if" scenarios—for example,
changing the format of the data in a file—without adversely affecting the data on your
local disk.
For more information, see
112
was not created as indicated in the Details area, you must perform a manual
backup as described in
can remotely boot only from backups that were performed after remote boot
was enabled.
122.
98. Repeat this procedure for enabling remote boot until all parts
®
Client Backup and Recovery, there are several ways to recover data from
"Recovering Files or Folders" on page
"Manually Backing up Your Disk" on page
"Recovering a System Disk While Booting Remotely"
®
Intel Entry Storage System SS4000-E User Guide
105. You
"Protecting
114.