Intel SS4000-E - Entry Storage System NAS Server User Manual page 39

6. By default, if your network has a DHCP server, the storage system obtains its IP
address from that server.
If your network does not have a DHCP server or if the storage system is directly
attached to your computer, the default IP address and subnet mask are used. The
default IP address is 192.168.0.101, and the default subnet mask is 255.255.255.0.
To accept the default settings, click Next. Otherwise, specify the desired settings and
then click Next.
When you click Next, the Disk Configuration page displays. The options that display
on this page vary, depending on the number of hard disks currently installed in the
system.
Caution:
7. If you want to add or remove hard disks, do so one at a time and click Scan after each
action.
Note: It is strongly recommended that you install all the hard disks you want to use
To accept the default disk configuration, which provides the best level of data
protection available for the number of hard disks currently installed, click Next. By
default, a linear disk configuration is used for a single hard disk, RAID 1 is used for
two hard disks, and RAID 5 is used for three or four hard disks.
®
Intel Entry Storage System SS4000-E User Guide
RAID 0 and linear disk configurations do not offer any data protection. If
you lose a hard disk, data loss occurs.
in the storage system at this time, since changing the number of hard disks
later can require disk reconfiguration and possible data loss.
Getting Started
23