Intel SS4000-E - Entry Storage System NAS Server User Manual page 141

12. Click Restore Disk. The Restore dialog box displays.
13. Specify whether you are recovering to the original disk or a new disk.
If you are recovering to a new disk, select the desired disk from the list and then click
Restore.
14. When the confirmation message displays, click Yes.
The backup is recovered to your local disk, and the progress bar displays the progress
of this process. You can cancel the recovery at any time by clicking Stop on the
progress dialog box.
Note: Do not shut down your computer, disconnect from the network, or perform
15. After the recovery is complete, click OK to restart your computer.
16. Use the appropriate procedure for your computer to configure it to boot from the local
disk once more.
17. If you changed the recovery password, reset it in the Microsoft iSCSI Initiator* after
your computer restarts as described in
Microsoft iSCSI Initiator*" on page
18. Start Intel
and partitions as described in
remote boot and restarts your computer. Then protect them again as described in
"Protecting Your Disks" on page
If you need to recover other data disks or partitions, you can do so as described in
"Recovering a Data Disk" on page
protection and then reprotect the disks.
19. Enable remote boot again as described in
®
Intel Entry Storage System SS4000-E User Guide
any other tasks until this process is complete.
®
Client Backup and Recovery and remove protection from all your disks
"Removing Protection" on page
"Resetting the Recovery Password in the
166.
98, reusing the existing backups.
116. However, you must do this after you remove
"Enabling Remote Boot" on page
Protecting Local Disks
126. This disables
111.
125