Dynacord DSP 600 Owner's Manual page 31

R
OUTING
Input selections (In-A, In-B or In-A+B) can be applied to any or all of DSP 600's six outputs. Choose a desired output
channel from the output menu and press the Edit button to scroll to the Routing window using the Value up/down ar-
rows.
Using the <SELECT> buttons to navigate to the Source parameter, apply a desired input selection to a selected output
channel using the VALUE up/down buttons to choose between inputs (In-A, In-B or In-A+B).
A P EQ
RRAY ARAMETRIC
Use the < SELECT > buttons to make the top line of the Edit screen active and the Value Up and Down buttons
to navigate to the Array Eq screen. In the ARRAY CONTROL section an 5-band parametric equalizer is available
for each output.
Use the < SELECT > buttons to navigate to the filter setting (see table below) you wish to adjust, and the Value Up and
Down buttons to alter these settings. Press the Value Up and Down buttons once to increment values by one unit, or
press and hold to scroll rapidly through available values.
A D
RRAY ELAY
Use the < SELECT > buttons to make the top line of the Edit screen active and the Value Up and Down buttons to navigate
to the Array Delay screen. In the ARRAY CONTROL section a delay is available for each output.
HINT: The Array Delay parameter can be used for adjusting the individual cabinets within a loudspeaker cluster,
such as a subwoofer array or a center loudspeaker cluster. For example, in a speaker cluster consisting of
two horn-loaded loudspeakers, it is helpful to apply 3-5 mS of delay to one of the loudspeakers in the cluster
to improve the coverage in the overlap of the horn patterns. Additionally, the array delay provides a conve-
nient section to apply dedicated delay to individual subwoofer cabinets to create gradient or beam-formed
arrays.
Unit
sec
ms
μs
samples
feet
inch
meter
cm
Table 5-10: Input Delay units
OUT 1:Routing
Source: In B
OUT 1:Array PEQ1
Type: PEQ
Q: 0.7
Type Frequency Slope / Order
6dB/oct.
Loshelv
12dB/oct.
6dB/oct.
Hishelv
12dB/oct.
PEQ
20 to 20000 Hz
Lopass
6dB/oct.
12dB/oct.
Hipass
Allpass
Table 5-11: Array Control EQ
Description
seconds
milliseconds
microseconds
samples
feet
inch
meters
centimeters
Active
F:30.0Hz
Gain: 1.0dB
Resp / Q Gain
-
-18.0 to +12.0 dB
-
- 0.40 to 40
-
-
0.4 to 2.0
-
1 -
-
2 0.4 to 2.0
DSP 600
31