Xerox DocuColor DocuColor 4 Setup Manual page 21

A power specification is listed below. The specifications that apply to your
machine depend on your machine configuration. Connect the power plug only
to a properly rated power outlet. Otherwise, it can cause a fire or shock ha-
zard. If in doubt, contact the Xerox Customer Support Centre.
Rated voltage: 110 - 120 or 220 - 240V
Rated frequency: 50/60Hz
Never use multi-plug adaptors to plug multiple power plugs in the same outlet.
Be sure to operate the machine on a sole-use receptacle. Multiple connectors
can cause the outlet to overheat and cause a fire.
Ensure that the plug connection is free of dust. In a damp environment, a
contaminated connector can draw a non-negligible amount of current that can
generate heat and eventually cause a fire over an extended period of time.
Always use the power cord provided with your machine. When an extension
power cord is required, always use a properly rated cord.
Contact the Xerox Customer Support Centre.
If you use a cord with an unspecified current rating, the machine or plug may
emit smoke or become hot to the touch externally.
Do not attempt to rework, pull, bend, chafe, or otherwise damage the power
cord. Do not place a heavy object on the cord. A damaged cord can cause a
fire or shock hazard.
Never touch a power cord with wet hands. Danger of electric shock exists.
Stop operation immediately if your machine produces smoke, excessive heat,
unusual noise, or smell, or if water is spilt into the machine. These conditions
can result in a fire. Immediately switch off and unplug the machine, and con-
tact the Xerox Customer Support Centre.
To prevent a fire or shock hazard, follow the instruction below based on your
machine configuration. If in doubt, contact the Xerox Customer Support Cen-
tre.
xix